If you have problems
ENVI-MAG Manual C2-15
Installation
Error messages
The following error messages can be encountered during the installation, if some
unexpected conditions are present. A description of the likely cause and a
possible remedy are described for each message.
“ An unexpected error has occurred” during
installation
This message is displayed if the INSTALL procedure failed for any reason.
The following are possible causes, in order of likelihood:
1. You have entered the INSTALL command incorrectly. The syntax for
the
INSTALL command follows:
INSTALL a: c: \ENVIMAP
The most common errors are:
▲ failing to separate each parameter by a space,
▲ not preceding the destination directory by a “\” character,
▲ including a disk drive designation with the destination directory.
The command you entered is displayed on the screen followed by the
correct syntax and a correct example. Check your command carefully
to determine the error.
2. PKUNZIP.EXE was not found on the installation diskette. This can only
be caused by a corrupted INSTALLATION DISK.
3. A program named GSETUP.EXE failed to change your AUTOEXEC.BAT
or
CONFIG.SYS files. There may be something unusual about your
system which is not accounted for in the ENVIMAP installation. You
will have to attempt a manual installation. (See “Manual installation”
on page C2-14.)
“ Out of environment space” during re-boot
If during re-boot the following DOS message occurs:
Out of environment space
To Next Page
Loading...
Need help?
General