ENVIMAP Installation
C2-18 ENVI-MAG Manual
Another possibility is that not all files were expanded into the destination
directory. This may be due to one or more disks being skipped during
installation, or because you ran out of disk space. You can confirm which is
the problem by checking the amount of free disk space that remains.
Cannot find files when running the software
This can be due to the ENVIMAP path not being included in the system PATH.
1. Press
Fx
to exit ENVIMAP.
2. Type PATH to determine the current PATH setting.
3. If it is not correct (i.e. you do not see the directory where you loaded
ENVIMAP), you must modify your
AUTOEXEC.BAT file to correctly set
the system path.
The installation procedure attempts to make this change automatically, but
some AUTOEXEC.BAT procedures are too complex for the installation
procedure to get this right. Please carefully review what your
AUTOEXEC.BAT
is doing. If you did not configure your system, find the person who did
and explain the problem.
Cannot view a plot file
If you cannot view a plot file it may be because the installation procedure
was not run correctly.
1. Set the default directory to the ENVIMAP directory.
2. Enter: ENVIMAP
3. From the SYSTEM CONFIGURATION menu, select the
Video and Printer Setup option.
4. Select either the EGA or VGA option to match the capabilities
of your computer.
To Next Page
Loading...
Need help?
General