Maintenance
A7-6 ENVI-MAG Manual
Instrument disassembly/assembly
Warning: Disassembly of the console is strongly discouraged due to its complexity,
but should disassembly of the console be required proceed as follows:
1. Place the console, face down, onto a flat smooth surface.
2. Unscrew the screws on both sides of the battery cover.
3. Lift off the cover.
4. Remove the battery.
5. Unscrew the eight screws.
6. Lift off the rear panel carefully.
7. Watch for the wires.
8. Place the panel above the instrument on the surface.
9. Turn the console over.
10. Lift off the front panel carefully.
11. Place it to the left of the console.
12. Take care of the cable.
13. Clean all connecting surfaces before re-assembly, including the O-rings
under the eight screws.
14. Make sure that the wires coming from the power connector located at the
bottom left hand side of the display module are placed side by side and
that all other wiring is placed such as not to get pinched.
15. Repeat steps 1 to 12 in reverse order to assemble the console again.
16. If available, apply a small amount of oil or grease to the O-rings.
17. Tighten up the screws with a medium-sized slotted screwdriver.
Do not overtighten.
To Next Page
Loading...
Need help?
General