ENVIMAP Installation
C2-16 ENVI-MAG Manual
you must increase the size of the DOS environment. The DOS environment
contains default system settings, including the current system PATH and the
\ENVIMAP directory name. This installation has brought the contents of the
environment over the current system limit.
To increase the limit, add the following command to
C:\CONFIG.SYS:
SHELL=C:\COMMAND.COM C:\ /P /E:3000
where /E:3000 is the environment size in bytes. If the SHELL command
already exists in the
CONFIG.SYS file, modify it by adding at least 512 bytes
to the size as currently defined.
You must re-boot the computer after changing
CONFIG.SYS. Make sure that
there are no DOS error messages during re-boot. If there are, check
CONFIG.SYS and resolve all messages.
“ Could not load
SUSHIØ.EXE” when trying
to run ENVIMAP
This error is caused by the ENVIMAP environment variable being set incorrectly.
Use the DOS command
SET to determine the presence of a GEOSOFT
environment variable, and its setting. You must change or add the command:
SET GEOSOFT=C:\ENVIMAP
to the AUTOEXEC.BAT file in your boot directory, (where C:\ENVIMAP is the
full path of the directory in which you installed the ENVIMAP System).
The installation procedure attempts to make this change automatically, but
some
AUTOEXEC.BAT procedures are too complex for the installation
procedure to get this right. Please carefully review what your
AUTOEXEC.BAT
is doing. If you did not configure your system, find the person who did and
explain the problem.
Cannot find files during system configuration
This problem is most likely caused by not being in the \ENVIMAP directory
when running the INSTALL menu. The current directory is displayed in the
bottom left corner of the ENVIMAP screen.
To Next Page
Loading...
Need help?
General