SCINTREX ENVI-MAG - General Setup Principles

Setup
A4-4 ENVI-MAG Manual
General setup principles
Setting up the ENVI-MAG consists of:
▲ bringing up the various display screens,
▲ moving the cursor to different parameter fields,
▲ then either selecting from a list, or entering appropriate values.
It is assumed that you have performed a configuration selection (as shown on
page A4-3) and have one of the following three Main operating displays:
Figure A-36 Main operating displays for all modes
MODE: t-fld DUR: 0.5s
TUNE FIELD: 60000
AUTO TUNE: yes ST: 0. +
TM/DT: OUTPUT: SEP: 0.
BASE: TIE:
ERASE MEMORY: LN: 0. +
SEP: 0.
Chg?:+- 000 help:INFO BATT:134
locations
MODE: srch. DUR:0.5s
TUNE FIELD: 60000
AUTO TUNE: yes
TM/DT:
Chg?:+- 000 help:INFO BATT:134
00000 START 00000 of:
MAG: mmmm ST: sss.s d
SEP: pppp.p
LN: llll.l d
SEP: pppp.p
Measure:START 00000 ALL keys BATT:bbb
measurement
locations
Basic mode
Search mode
Advanced mode
(Config. 1–3)
(Config. 4)
(Config.5–7)