Advanced Mode
ENVI-MAG Manual A4-29
Setup
Reprogramming the
operating system
The flash EPROM’s (erasable, programmable read only memory) of the
ENVI-MAG can be updated from your computer using the software supplied by
SCINTREX.
At the computer
1. Note the name of the upgrade program (usually DASPROM.SYS)
written on the label of the supplied disk.
2. Insert the supplied disk into your floppy drive (A: or B:).
3. Start the program FLASHCOM, i.e. enter
flashcomL.
4. Depending upon the type of display your PC has, enter one of:
k
— for monochrome display
c
— for CGA displays
v
— for VGA displays
5. You will then be asked to enter the name of the download program
from step 1, i.e. DASPROM.SYS or what ever was on the disk.
6. The PC will display: “WAITING...”. At this point it is waiting for the
ENVI-MAG console to come on line.
At the ENVI-MAG
Warning: Make sure you have dumped all of your data, otherwise it will be erased.
From the Main operating display in the advanced mode:
1. Press the “AUX/LCD” key to bring up the Auxiliary display.
1
To Next Page
Loading...
Need help?
General