Operation
A5-14 ENVI-MAG Manual
4. Move cursor to AUTO TUNE:
5. Select! NO.
6. Press the “ESCAPE” key.
7. Press the “START” key. You will see prompts asking for the cable length you
are using.
8. Press either the “2” key for the (LONG) standard 50m base-station cable or
the “3” key for the (
SHORT) total-field sensor and cable.
9. Press the “NUM/GRAPH” key to display the graph.
10. Press the “+” or “–” key to change the sensitivity of the graph.
You can also press the “0” (zero) key to center the graph vertically.
To Next Page
Loading...