Menu Reference
ENVI-MAG Manual C3-17
Reference
Scale bar
The following options control the location and units of the scale bar.
1. Show scale bar?
A YES or NO answer is required.
2. ground units
You must specify whether the ground units of the data are in
metres or feet.
3. locate relative to map:
You can specify either the bottom right, bottom centre or bottom left
of the map as the location to plot the scale bar.
Note: The Titles are always plotted in the bottom centre portion of the map.
4. X-offset
This option allows you to specify how much in centimetres on the
plotted map to offset the scale bar in the horizontal direction from
the reference point mentioned above. A negative offset will be to
the
left.
5. Y-offset
This option allows you to specify how much in centimetres on the
plotted map to offset the scale bar in the vertical direction from the
reference point mentioned above. A negative offset will be down
the map sheet.
North Arrow
This group of options allows you to control the placement, orientation
and annotation of the north arrow.
1. Show North Arrow?
A YES or NO option to show the north arrow.
To Next Page
Loading...
Need help?
General