Instrument
A3-20 ENVI-MAG Manual
TM/DT
This option allows you to set the time and date of your
ENVI-MAG.
You must press the “ENTER” key.
A pop-up window will be displayed showing the current
values of TIME and DATE in your instrument. Use the
arrow keys to move the blinking cursor to the field you
wish to change. Press “ENTER” again and enter the value
from the keypad. Finish the entry by pressing “ENTER”
one more time.
To get back to the main menu, press the “ESC” key.
NOTE: This is optional, since no data are recorded in the
search mode.
Chg?+_
ENTER
Depending upon which field the cursor is located in, you
will see one of these prompts.
Chg?:+- allows you toggle a selection from an
internal list by pressing either the “+” or “-” keys.
ENTER: Pressing “ENTER” will either pop-up a window
for further operation or let you enter a numeric value
(terminated by another press of the “ENTER” key)
help:INFO
This prompt indicates that the help screens are available
when you press the “INFO” key.
BATT:
The voltage of the main battery. The normal range is
between 100 and approximately 140 when the charger is
connected.
The instrument may turn off without warning when the
value drops below 100 and will not allow more
measurements.
The data however still remains intact in memory, as long
as the main battery remains connected.
Parameter Description
To Next Page
Loading...
Need help?
General