Advanced Mode
ENVI-MAG Manual A4-15
Setup
5. Move the cursor to MODE:
6. Select! t-fld or grad from the following list:
off t-fld grad base.
7. Move the cursor to DURATION:
8. Select! 0.5 sec from the following list: 0.5 sec, 1 sec, 2
sec.
9. Move the cursor to TUNE FIELD:
10. Enter! the ambient magnetic field value of your survey area.
Please refer to Figure B-4 on page B1-4, if this value is unknown.
11. Ignore BASE CORRECT:
12. Ignore TIE CORRECT:
13. Move the cursor to REMOTE:
14. Select! no
15. Move the cursor to CYCLE TIME:
16. Enter! 0 (this parameter is used in the base-station mode only and
should be 0 for all other modes).
3
=
3
=
3
3
3
3
=
3
0
To Next Page
Loading...