Setup
A4-18 ENVI-MAG Manual
The MAG SETUP display now appears.
MODE: mmm CYCLE TIME: ttt
DURATION: ddd CHART SCALE: sss
TUNE FIELD: fffff AUTO TUNE: yn
BASE CORRECT: yn BASE FIELD: bbbbb
TIE CORRECT: yn TIE-MODE: lll
REMOTE: yn AUTO RECORD: yn
Chg?:+- BAT:bbb
9. Move the cursor to MODE:
10. Select! grad. from the following list: off t-fld grad.
base.
11. Move the cursor to DURATION:
12. Select! 2 sec from the following list: 0.5 sec, 1 sec, 2 sec.
13. Move the cursor to TUNE FIELD:
14. Enter! the ambient magnetic field value of the survey area. Please refer to
Figure B-4 on page B1-4, if this value is unknown.
15. Ignore BASE CORRECT:
16. Ignore TIE CORRECT:
17. Move the cursor to REMOTE:
18. Select! no
19. Move the cursor to CYCLE TIME:
mag setup
3
=
3
=
3
3
3
3
=
3
To Next Page
Loading...
Need help?
General