boards.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
3-385
Nur für den internen Gebrauch Boards for HiPath 3000
Options
Slot
Insert the REALS board into the slot marked 3 in the lower part of the shelf in the basic cabinet
and apply pressure until you hear a click (see Figure 4-21).
The slots for the power supply units and for the REALS board must be covered with an outer
panel before the system is started up. The outer panel is fixed onto the shelf with screws (see
Figure 3-146).
Cable and connector assignment
Table 3-183 shows the assignment of the SIVAPAC connector X116 on the backplane and the
assignment of the jumper strip in the MDFU-E.
Figure 3-146 REALS Slots in the Basic Cabinet (With Outer Panel Mounted)
To Next Page
Loading...
