Siemens LOGO! - Deleting the Circuit Program

97
LOGO! Manual
A5E00380835-01
AQ1: 00000
AQ2: 00000
3. Enter a specific output value for each of the two analog
outputs.
4. To confirm your entry: Press OK
3.7.12 Deleting the circuit program
To delete a circuit program:
1. Switch the LOGO! to programming mode
>Program..
Card..
Setup..
Start
LOGO! opens the main menu
2. On the main menu, press or to move the ’>’ cursor
to ’Program’. Press OK.
>Edit..
Clear Prg
Password
LOGO! changes to the programming
menu
3. Move the ’>’ cursor to ’Clear Prg’: Press or
4. Confirm ’Clear Prg’: Press OK
Clear Prg
>No
Yes
To cancel deletion of the circuit program, leave the ’>’ cur-
sor at ’No’ and press OK.
Pro
g
rammin
g
LOGO!