Siemens LOGO! - Setting the Display Contrast; To Set the Display Contrast in Parameter Assignment Mode; To Set the Display Contrast in Programming Mode; To Set the TOD and the Date in Programming Mode

243
LOGO! Manual
A5E00380835-01
To set the TOD and the date in programming mode:
If you want to set the TOD and the date in programming
mode, select in the main menu ’Setup’, then menus ’Clock’
and ’Set Clock’. You can now set the weekday and the
time as described earlier (as of step 8.).
5.2.2 Setting the display contrast
You can set the default value for the display contrast
 in parameter assignment mode by means of the set
menu (“Contrast” menu item)
 in programming mode by means of the setup menu
(“Contrast” menu item).
To set the display contrast in parameter assignment mode:
1. Select parameter assignment mode (see Chapter 5.1.)
2. On the parameter assignment menu,
select ’Set..’: Press or
3. Confirm ’Set..’: Press OK
4. Move the ’>’ cursor to ’Contrast’: Press or
5. Confirm ’Contrast’: Press OK
LOGO! shows the following display:
Contrast
–.... ....+
6. To change the display contrast: Press or
7. To confirm your entry: Press OK
To set the display contrast in programming mode:
If you want to set the display contrast in programming
mode, select in the main menu ’Setup’, then menu ’Con-
trast’. You can now set the display contrast as described
earlier (as of step 6.).
Confi
g
urin
g
LOGO!