Siemens LOGO! - 5.1 Selecting parameter assignment mode

LOGO! Manual
A5E00380835-01
234
5.1 Selecting parameter assignment mode
Press ESC to change from RUN to parameter assignment
mode:
... Press
2005-01-27
Mo 09:00
ESC
Note
The following applies to earlier device versions up to
0BA2:
 You open parameter assignment mode by pressing
ESC+OK.
LOGO! changes to parameter assignment mode and opens
the parameter assignment menu:
>Stop
Set Param
Set..
Prg Name
Confi
g
urin
g
LOGO!