Siemens LOGO! - Enabling Summertime;Wintertime Conversion

99
LOGO! Manual
A5E00380835-01
To enable/disable automatic S/W Time conversion in
programming mode:
1. Switch the LOGO! to programming mode.
2. You are now in the main menu and want to select the
’Setup’ menu command: Press
or
3. Confirm ’Setup’: Press OK
4. Move the ’>’ cursor to ’Clock’: Press or
5. Confirm ’Clock’: Press OK
6. Move the ’>’ cursor to ’S/W Time’: Press or
7. Confirm ’S/W Time’: Press OK
LOGO! shows the following display:
>On
Off
S/W Time:
Off
The current setting of automatic S/W Time conversion is
shown on the bottom row. The default setting is ’Off’: dis-
abled.
To enable/disable automatic S/W Time conversion in
parameter assignment mode:
If you want to enable/disable automatic S/W Time
conversion in parameter assignment mode, select in the
parameter assignment menu ’Set..’, then menus ’Clock’
and ’S/W Time’. You can now enable/disable automatic
S/W Time conversion.
Enabling summertime/wintertime conversion
You now want to enable this conversion and define or set
its parameters:
1. Move the ’>’ cursor to ’On’: Press or
2. Confirm ’On’: Press OK
The display shows:
Pro
g
rammin
g
LOGO!