79
LOGO! Manual
A5E00380835-01
The following character set is available:
A B C D E F G H I J K L M N O
P Q R S T U V W X Y Z a b c d e
f g h i j k l m n o p q r s t u
v w x y z 0 1 2 3 4 5 6 7 8 9 !
” # $ % & ’ ( ) * + , – . / : ;
< = > ? @ [ \ ] ^ _ ‘ { | } ~
Let us assume you want to name your circuit program
“ABC”:
5. Select “ A”: Press
6. Move to the next letter: Press
7. Select “ B”: Press
8. Move to the next letter: Press
9. Select “ C”: Press
10.To confirm the complete name: Press OK
Your circuit program is now named “ABC”, and you are re-
turned to the programming menu.
To change the name of your circuit program, proceed in
the same way.
Note
You can change the name of the circuit program only in
programming mode. You can read the name both in pro-
gramming and in parameter assignment mode
3.7.5 Password
You can protect a circuit program from unauthorized access
by assigning it a password.
To assign a password
Pro
To Next Page
Loading...
