81
LOGO! Manual
A5E00380835-01
Note
You can cancel the input of a new password with ESC. In
this case, LOGO! returns to the programming menu with-
out saving the password.
You can also set your password using LOGO!Soft Comfort.
You can not edit a password-protected circuit program at
the LOGO! or upload it to LOGO!Soft Comfort unless you
enter the correct password.
To allow you to create and edit a circuit program for a pro-
tected module (Card), you first need to assign a password
to this new program (see Chapter 6.1).
Changing the Password
You need to know the current password in order to change
it.
In the programming menu:
1. Move the ’>’ cursor to ’Password’: Press or
2. To confirm the ’Password’: Press OK
Select “Old” and enter your old password (in our case: ’AA’)
by repeating steps 3 through 6 as described earlier.
The display now shows:
Old:
AA
New:
Now you can select “New” to enter the new password, e.g.
“ZZ”:
3. Select “Z”: Press
4. To move to the next letter: Press
5. Select “Z”: Press
Pro
To Next Page
Loading...
