Siemens LOGO! - 4.1 Constants and connectors - Co

LOGO! Manual
A5E00380835-01
104
To enable/disable synchronization in programming mode:
1. Switch the LOGO! to programming mode.
2. You are now in the main menu, and want to select
’Setup’: Press
or
3. Confirm ’Setup’: Press OK
4. Move the ’>’ cursor to ’Clock’: Press or
5. Confirm ’Clock’: Press OK
6. Move the ’>’ cursor to ’Sync’: Press or
7. Apply ’Sync’: Press OK
LOGO! shows the following display:
>On
Off
Sync:
Off
The current setting of the automatic synchronization func-
tion is displayed on the bottom row. The default setting is
’Off’, i.e. disabled.
To enable/disable synchronization in parameter
assignment mode:
If you want to enable/disable automatic synchronization in
parameter assignment mode, select in the parameter as-
signment menu ’Set..’, then menus ’Clock’ and ’Sync’. You
can now enable/disable automatic synchronization.
Enabling synchronization
You want to enable synchronization:
1. Move the ’>’ cursor to ’On’: Press or
2. Confirm ’On’: Press OK
LOGO! shows the following display:
>On
Off
Sync:
On
Pro
g
rammin
g
LOGO!