LOGO! Manual
A5E00380835-01
ii
Valid range of this manual
The manual applies to devices of series 0BA5.
Changes compared to previous releases of the manual
The digital modules LOGO! DM16 24, DM16 24R and DM16
230R were added.
The analog module LOGO! AM 2 AQ was added.
The communication modules CM EIB/KNX and CM AS
interface were added.
Description of changes and new features of the series 0BA5
devices.
Main differences compared to previous devices (0BA0 to 0BA4)
Display contrast may be changed
Default setting for the start screen may be changed
New features of the current devices (0BA5)
The “Analog ramp” special function enables you to use a
two-step speed control.
The “Analog multiplexer” special function enables you to select
1 of 4 analog values to be output.
The “PI controller” special function enables you to use a PI
controller function.
Additional support
At our Internet address
http://www.siemens.com/logo
you can quickly and easily find answers to your queries about
LOGO!.
You can reach Technical Support as follows:
Phone: +49 (0)180 5050-222
Fax: +49 (0)180 5050-223
E-Mail: adsupport@siemens.com
Preface
To Next Page
Loading...
