Detailed description
2.6 Interface structure
Basic logic functions: PLC basic program solution line (P3 sl)
36 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
The triggering and parameter assignment of NCK functions is performed by means of PLC
function calls.
The following function calls are available, for example:
• Position a linear axis or rotary axis
• Position an indexing axis
• Start a prepared asynchronous subprogram (ASUB)
• Read/write NC variables
• Update magazine and tool movement
Some of the above functions are described in their own function documentation.
3URJUDPFRQW
URO
7UDYHUVHVLJQDOV
*(2D[HV
%\WHV
3URJUDPFRQW
UROIURP+0,
3URJUDPFKDQQHO
6WDWXV
*HRD[HVVWDWXV
067''/+)
9DOXHV
'HFRGHG0VLJQDOV
00
$FWLYH*IXQFWLRQV
'%
0GHFRGHU
0&3
+0,
1&
&KDQQHO
*JURXS
GHFRGHU
06)
'LVWULEXWRU
$[LVVSLQGOH
,QWHUIDFH
&RQWUROVLJQDOV
6WDWXVVLJQDOV
$X[LOLDU\*IXQFWLRQV
%3
%3
3URWHFWLRQ]RQHV
$FWLYDWLQJ
6WDWXVVLJQDOV
3URWHFWLRQ]RQHV
$X[LOLDU\IXQFWLRQ
FKDQJHVLJQDOV
+0,
URXWLQJ
6LJQDO
Figure 2-7 PLC/NCK channel interface
To Next Page
Loading...
Need help?
General
