SimCom SIM5300E - Page 144

SIM5300E AT Command Manual V1.02
133
Read Command
AT+CGEREP?
Response
+CGEREP: <mode>,<bfr>
OK
Write Command
AT+CGEREP=<mode>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Unsolicited Result Codes supported:
+CGEV: NW DEACT <PDP_type>,<PDP_addr>[,<cid>]
+CGEV: ME DEACT <PDP_type>,<PDP_addr>[,<cid>]
+CGEV: NW DETACH
+CGEV: ME DETACH
Parameters <PDP_type> Packet Data Protocol type (see +CGDCONT Command)
<PDP_addr> Packet Data Protocol address (see +CGDCONT Command)
<cid> Context Id (see +CGDCONT Command)
<mode>
0
buffer unsolicited result codes in the MT; if MT result code
buffer is full, the oldest ones can be discarded. No codes are
forwarded to the TE.
1 discard unsolicited result codes when MT-TE link is reserved
(e.g. in on-line data mode); otherwise forward them directly
to the TE
2 buffer unsolicited result codes in the MT when MT-TE link is
reserved (e.g. in on-line data mode) and flush them to the TE
when MT-TE link becomes available; otherwise forward them
directly to the TE.
<brf>
0
MT buffer of unsolicited result codes defined within this
command is cleared when <mode>1 or 2 is entered.
1
MT buffer of unsolicited result codes defined withen this
command is flushed to the TE when <mode> 1 or 2 is entered.
Reference
SIMCOM CONFIDENTIAL FILE