EasyManua.ls Logo

Strata CIX 100 - Page 340

Default Icon
508 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP Telephone Programming
IP Telephone Installation and Network Connection Setup
8-26 Strata CIX Programming Vol.1 12/09
33 Call Forward Dial
Tone
When the handset is picked up the user will hear stutter dial tone if Station Call Forward
is set on the telephone.
Possible values:Enabled (Default) or Disabled
34 Dialing Digit
Restriction
After the extension has made a call it can be prevented from dialing any subsequent
digits.
Possible values:Enabled or Disabled (Default)
35 CO Park & Hold Enabled: When this station parks a line call, CO or GCO buttons of the parked line that
appear on other stations will be on hold. This will allow the other stations to press the
CO or GCO button to pickup the parked call.
Disabled: When this station parks a line call, CO or GCO buttons of the parked line that
appear on other stations will appear busy. This will prevent the other stations to press
the CO or GCO button to pickup the parked call.
Possible values:Enabled or Disabled (Default)
36 MW & DND Dial
Tone
Enable: When this station goes off hook, the station will receive stuttered dial tone
when it has a message waiting indication and the station will receive a busy tone burst
before dial tone when in the DND mode.
Disable: This station will receive normal dial tone when it has a message waiting or
when it is in the DND mode.
Possible values:Enabled (Default) or Disabled
37 Activate Message
Waiting
Enable: This station is allowed to activate station-to-station message waiting on other
stations by dialing the other station number plus 7, 8, or 9, or by pressing the Msg key.
Disable: This station cannot activate station-to-station message waiting on other
stations by dialing the station number plus 7, 8, 9, or by pressing the Msg key.
Note: This parameter does not apply to voice mail ports, they use the special message
waiting access codes.
Possible values:Enabled (Default) or Disabled
38 Tenant Number Enter the Tenant number to which this PDN should be assigned.
Possible values:1(default) ~ 8
39 Hook-Switch
Recall
1: Enable Recall for Digital Telephones for normal operation.
2: Disable Recall on Standard Telephones that produce hook-switch bounce when they
are hung-up. This prevents annoying ring recalls when the user hangs up on a call.
Possible values:Enabled (Default) or Disabled
F
IELD DESCRIPTION

Table of Contents