Software and Firmware Updates
IP Telephone, MIPU, GIPU, LIPU and BIPU Firmware Update Procedures
Strata CIX Programming Vol.1 12/09 B-7
Software and
Firmware Updates
xIPU Update
Important! Complete all “Prerequisites” on page B-6 before you do the following.
Store the IP update files on the external ftp sever
1. Create an ftp directory and name it CTXIPUPDATE.
2. Copy the xIPUXXX update files to CTXIPUPDATE directory (XXX is the xIPU firmware version level).
From the Network eManager PC perform the xIPU update
Important! The xIPUs and IP telephones will automatically be disabled while Update takes place and
return to the idle state when Update is complete (if they were in the idle state when the
Update was started).
1. Select Maintenance > IP Firmware Update > IPT_L/M/G Update.
2. Select the xIPU card slot (regarding BIPU - only BIPU-M can be updated. Only BIPU-M card slots will
be shown with Network eManager. The BIPU type selection is not required).
3. Select Other (radio button).
4. Enter the ftp user login Name and Password.
5. Enter the IP address external ftp server.
6. From Data Directory box enter: CTXIPUPDATE.
7. From File Name box enter: xIPUXXX.
8. Click Start and observe the update status: Getting Updated file\Updating\Finished
Updating\Resetting\idle.
Notes
• It can take one to five minutes to update the LIPU.
• If an error occurs, recheck file names, locations, etc., then try again.
9. After the update is complete, select IP-Telephony > BIPU Configuration or L/M/G IPU
Configuration. Check the xIUP version numbers to verify they have been updated properly.
10. Press the xIPU reset button for proper initialization.
IP Telephone Update
Important! Complete all “Prerequisites” on page B-6 before you do the following. Refer to the Cautions
on Page B-1.
Store the IP update files on the external ftp sever
1. Create an ftp directory and name it CTXIPUPDATE
2. Copy the IP5 or DIP update files to the CTXIPUPDATE directory (XXX is the IPT firmware version
level).
From the Network eManager PC perform the update
Important! The xIPUs and IP telephones will automatically be disabled while Update takes place and
return to the idle state when Update is complete (if they were in the idle state when the
Update was started).
1. Select Maintenance > IP Firmware Update > IPT_L/M/G Update.
2. Select the IP PDN to be updated.
3. Enter the external server ftp user login Name and Password.
4. Enter the IP address external ftp server.
To Next Page
Loading...