Thermo Scientific Applied Biosystems SeqStudio Genetic Analyzer - APPENDIX B Link the Instrument to Your Connect Cloud-Based Platform Account-Detailed Instructions; Workflow: Set Up the Instrument for Connect Cloud-Based Platform Access

Link the instrument to your Connect
cloud-based platform account—
detailed instructions
■
Workow: Set up the instrument for Connect cloud-based platform access .. 184
■
Network requirements ............................................... 184
■
Link the instrument from a mobile device .............................. 185
■
Link the instrument using a link code .................................. 186
■
Set up email notications from the instrument .......................... 190
Workflow: Set up the instrument for Connect cloud-based platform
access
Register and obtain a Connect cloud-based platform account
(page 50)
▼
Link the instrument to your Connect cloud-based platform
account in any of the following ways:
• Link the instrument from a mobile device
(page 185)
• Link the instrument using a link code
(page 186)
Network requirements
The instrument is factory-congured for IPv4 TCP/IP communication and includes a
fast Ethernet adapter (10/100 Mbps) with a RJ45-type connector for integrating the
device into a local area network (LAN).
By default, the instrument is congured to use the Dynamic Host Conguration
Protocol (DHCP) but can use a static IP address.
The instrument should be congured behind a rewall. Contact Support for
information on required rewall exceptions.
B
184
SeqStudio
™
Genetic Analyzer Instrument and Software User Guide