Tonghui TH2829 Series - Page 197

TH2829X Series Operation Manual Chapter 10 HANDLER
188
TRAN :TURN :STAT ON (1)
OFF(0)
:FREQ <value>
:LEVel <value>
:Np LIMit <value>,<low limit>,<high limit>
:Ns LIMit <value>,<low limit>,<high limit>
:Lx :STAT ON (1)
OFF(0)
:FREQ <value>
:LEVel <value>
:LIMit <value>,<low limit>,<high limit>
:Lk :STAT ON (1)
OFF(0)
:FREQ <value>
:LEVel <value>
:LIMit <value>,<low limit>,<high limit>
:Zx :STAT ON (1)
OFF(0)
:FREQ <value>
:LEVel <value>
:LIMit <value>,<low limit>,<high limit>
:Cx :STAT ON (1)
OFF(0)
:FREQ <value>
:LEVel <value>
:LIMit <value>,<low limit>,<high limit>
:ACR :STAT ON (1)
OFF(0)
:FREQ <value>
:LEVel <value>
:LIMit <value>,<low limit>,<high limit>
:DCR :STAT ON (1)
OFF(0)
:LIMIt <value>,<low limit>,<high limit>
:MODE SEQ
STEP
The TRAN:TURN:STAT command is used to set the turn-ration ON or OFF. The
TRAN:TURN:STAT? query returns the current state of the turn-ratio.
Command syntax: