Tonghui TH2829 Series - Page 202

TH2829X Series Operation Manual Chapter 10 HANDLER
193
For example: WrtCmd (“TRAN:Zx:STAT:ON”) Set all Zx test parameters to be
valid.
Query syntax: TRAN:Zx:STAT?
Return format: <NR1><NL^END>
The TRAN:Zx:FREQ command is used to set the Zx test frequency. The
TRAN:Zx:FREQ query returns the current Zx test frequency.
Command syntax: TRAN:Zx:FREQ<value>
Where,
<value> is NR1, NR2 or NR3 data format followed by HZ, KHZ or MHZ.
For example: WrtCmd (“TRAN:Zx:FREQ 1KHZ”) Set the Zx frequency as 1KHZ.
Query syntax: TRAN:Zx:FREQ?
Return format: <NR3><NL^END>
The TRAN:Zx:LEVel command is used to set the Zx test level. The TRAN:Zx:LEVel
query returns the current Zx test level.
Command syntax: TRAN:Zx:LEVel<value>
Where,
<value> can be NR1, NR2 or NR3 data format followed by mV or V.
NOTE: <value> ranges from 5mV to 2V. Beyond this range, error information will
be reported.
For example: WrtCmd (“TRAN:Zx:LEVel 1V”)
Query syntax: TRAN:Zx:LEVel?
Return format: <NR3><NL^END>
The TRAN:ACR:STAT command is used to set the ACR test parameter to be ON or
OFF. The TRAN:ACR:STAT query returns the current state of the ACR test
parameter.
Command syntax:
ON
TRAN:ACR:STAT OFF
1
0
Where,
1 (decimal 49) is equal to ON.
0 (decimal 48) is equal to OFF.
For example: WrtCmd (“TRAN:ACR:STAT:ON”) Set the ACR test parameter to be
valid.
Query syntax: TRAN:ACR:STAT?
Return format: <NR1><NL^END>