Tonghui TH2829 Series - Page 3

TH2829X Series Operation Manual Contents
III
3.4.4 CMP (Compare)...............................................................24
3.5 <TRACE SWEEP> .................................................................24
3.5.1 FORMAT .........................................................................25
3.5.2 SCALE ...........................................................................25
3.5.3 READ .............................................................................25
3.5.4 TRACE ...........................................................................26
3.5.5 POINTS ..........................................................................26
3.5.6 TRIGGER ........................................................................26
3.5.7 SAVE CSV & SAVE AS .......................................................26
3.6 <MEAS SETUP> ....................................................................27
3.6.1 Trigger mode ..................................................................29
3.6.2 Auto level control function ................................................29
3.6.3 Bias current isolation function ...........................................30
3.6.4 Average .........................................................................31
3.6.5 Level monitor function .....................................................31
3.6.6 Delay time .....................................................................32
3.6.7 Output impedance ...........................................................32
3.6.8 Deviation test function .....................................................32
3.7 <CORRECTION> ...................................................................33
3.7.1 OPEN .............................................................................35
3.7.2 SHORT ...........................................................................36
3.7.3 LOAD .............................................................................38
3.7.4 Load correction test function .............................................39
3.7.5 Cable length selection ......................................................39
3.8 <LIMIT TABLE> ....................................................................40
3.8.1 Swap parameter ..............................................................40
3.8.2 Limit modes of compare function .......................................41
3.8.3 Set nominal value of tolerance mode ..................................42
3.8.4 Comparator function ON/OFF ............................................42
3.8.5 Auxiliary bin ON/OFF .......................................................43
3.8.6 HIGH/LOW .....................................................................43
3.9 <LIST SWEEP SETUP> ..........................................................44
3.9.1 MODE ............................................................................45
3.9.2 Test parameter ...............................................................45
3.9.3 Sweep parameter setup ...................................................46
3.10 TRACE SWEEP SETUP ............................................................46
3.10.1 Function.........................................................................47
3.10.2 Level .............................................................................47
3.10.3 DC Bias ..........................................................................47
3.10.4 Trace .............................................................................48
3.10.5 Range ............................................................................48
3.10.6 Scale .............................................................................48
3.10.7 Frequency ......................................................................48
3.10.8 Speed ............................................................................48