Tonghui TH2829 Series - Page 4

TH2829X Series Operation Manual Contents
IV
3.10.9 Format ..........................................................................48
3.10.10 Trigger ...........................................................................48
3.10.11 Mode .............................................................................48
3.10.12 Start delay .....................................................................49
3.10.13 Point .............................................................................49
3.10.14 Step delay ......................................................................49
3.10.15 Maximum and minimum ...................................................49
3.10.16 START ...........................................................................49
3.10.17 END ..............................................................................49
3.10.18 Coordination range settiing ...............................................49
Chapter 4 [SYSTEM] and <FILE MANAGE> ..............................................51
4.1 <SYSTEM SETUP> ................................................................51
4.1.1 MAIN FUNC ....................................................................51
4.1.2 ON BEEPERS ...................................................................52
4.1.3 PASS BEEP .....................................................................52
4.1.4 FAIL BEEP ......................................................................52
4.1.5 LANGUAGE .....................................................................53
4.1.6 THEME ...........................................................................53
4.1.7 PASS WORD ...................................................................53
4.1.8 BUS MODE (Reserved function) .........................................54
4.1.9 GPIB ADDR (Reserved function) ........................................54
4.1.10 TALK ONLY .....................................................................55
4.1.11 BIAS SRC .......................................................................55
4.1.12 BAUD RATE ....................................................................56
4.1.13 DATA/TIME .....................................................................56
4.2 LCR <FILE MANAGE> ............................................................56
4.2.1 Setup file for single-group component (*.STA) .....................57
4.2.2 U-disk manage performance .............................................58
4.2.3 Operation steps for file management ..................................59
Chapter 5 Execute LCR operation and some examples ..............................61
5.1 Correction operation ..............................................................61
5.1.1 Sweep correction.............................................................61
5.1.2 Point-frequency correction ................................................61
5.2 Correct connection of DUT ......................................................62
5.3 Eliminate the influence of stray impedance ...............................63
5.4 Operation example for testing inductance with TH2829AX...........64
5.5 Operation example of testing capacitance by multi-frequency list
sweep 66
5.6 Operation example of load correction .......................................69
Chapter 6 Transformer Single-machine Test ............................................71
6.1 Circuit for transformer single-machine test ...............................71
6.1.1 Some parameters of transformer .......................................71
6.1.2 Transformer single test circuit and TURN test ......................71
6.1.3 Transformer leakage inductance test ..................................72