Toro TX525 - Page 196

ENGINE
4-143TX525 Service Manual Rev. 000
d. Usingtwo7/16”wrenches,tightenthetwo
adjustingnutssecuringthethrottlecabletothe
throttleplate(Fig.0621).
Fig 0621 PICT-7143a
6. Holdthethrottleleverovertothelowidlestop.Using
a1/4”wrench,tightentheswivelclampscrewtohold
thethrottlecablewire(Fig.0622).
Fig 0622 PICT-7111
7. Movethethrottlelevertothefastpositiontoensure
theenginethrottleleverrestsagainstthehighidle
stop(Fig.0623).
Fig 0623 PICT-7104
Note: When the throttle lever is in the fast position
the engine throttle lever should NOT contact
the throttle cable end (Fig. 0624).
Fig 0624 PICT-7123