Toro TX525 - Throttle Cable Installation

ENGINE
4-147TX525 Service Manual Rev. 000
14. Removetheclipsecuringthethrottlecabletothe
throttlehandlelinkage(Fig.0635).
Fig 0635 PICT-7151a
15. UnhookthethrottlecableZ-bendfromthethrottle
cablehandlelinkage(Fig.0636).
Fig 0636 PICT-7155
Throttle Cable Installation
16. Removethethrottlecablefromthemachine.
17. Removetheadjustingnutsfromthethrottlecable.
Retainthemforuseonthenewthrottlecable(Fig.
0637).
1. Threadtheadjustingnutsontothethrottlecable
approximatelyhalfwayupthethreadsleavingagap
betweenthetwonutstoaccommodatethethrottle
plate(Fig.0638).
Fig 0637 PICT-7158a
Fig 0638 PICT-7158a