Toro TX525 - Idler Arm Replacement; Idler Arm Removal

DRIVE SYSTEM
7-12 Rev. 000 TX525 Service Manual
Idler Arm Replacement
Idler Arm Removal
5. Using a 3/16” Allen wrench, remove the top 2
screws. Using a 1/2” socket, remove the bottom 2
screws securing the heat shield to the tower (Fig.
1304).
Fig 1302 Belt 001
Fig 1304 PICT-5258
6. Remove the heat shield (Fig. 1305).
4. Remove the prop rod (Fig. 1303).
Fig 1305 Belt 005
Fig 1303 Belt 003
1. Shut engine off, apply parking brake, and remove
ignition key.
2. Lift the engine hood assembly.
3. Remove the hairpin cotter from the prop rod (Fig.
1302).