Toro TX525 - ENGINE Cont.; Starter Assembly Testing; Brush Wear; Brush Holder

ENGINE
4-188 Rev. 000 TX525 Service Manual
Brush Wear
Brush Holder
Starter Assembly Testing
Fig 0790 PICT-8063a
1. Iftheconnectingfaceofthebrushisdirtyordusty,
cleanitwithemerypaper.
2. Measurethebrushlength(A)withverniercalipers.
3. Ifthelengthislessthantheallowablelimitof.354”
(9.0mm),replacetheyokeassemblyandthebrush
holder.
A. .354”(9.0mm)
1. Checkthecontinuityacrossthebrushholderandthe
holdersupportwithacircuittester.
2. Ifitconducts,replacethebrushholder.
Fig 0791 PICT-8069a
A