Toro TX525 - Electrical; Heat Shield Removal

ELECTRICAL
5-1TX525 Service Manual Rev. 000
Electrical
Many of the electrical components are located inside the
control panel. To access them, remove the heat shield.
3. Remove the hood rod (Fig. 0797).
Fig 0797 PICT-5257a
4. Using a 3/16” Allen wrench, remove the top 2 screws
securing the heat shield to the tower. Using a 1/2”
socket, remove the bottom 2 screws securing the
heat shield to the tower (Fig. 0798).
Fig 0798 PICT-5258
Heat Shield Removal
1. Raise the hood.
2. Remove the hairpin cotter from the hood rod (Fig.
0796).
Fig 0796 PICT-5256