Toro TX525 - Checking, Adding & Bleeding the Engine Coolant

ENGINE
4-138 Rev. 000 TX525 Service Manual
107. Filltheenginewithoilperspecications.
108. Filltheradiator.Referto“Checking,Adding&
BleedingtheEngineCoolant”onpage4-138.
109. Disengagetheparkbrakeandstarttheunit.
110. Adjustthethrottlecable.Referto“ThrottleCable
Adjustment”onpage4-142.
111. Purgeairfromthehydraulicsystem.Referto
“PurgingAirProcedure”onpage9-19.Checkfor
anyleaksatthehydraulicttingsandhoses.
112. Disengagethecylinderlockandlowertheloader
arms.
113. Closethehood.
106. Installtherearaccesspanel(Fig.0603).
Fig 0603 PICT-4505a
Checking, Adding & Bleeding the
Engine Coolant
1. Checkthelevelofcoolantintheexpansiontank.
Thecoolantshouldbeatorabovethemarkonthe
tank(Fig.0604).
Fig 0604 Coolant 001
Ifcoolantlevelislow,completethefollowingsteps:
Caution: Do not remove the coolant ll cap when the
engine is hot. Always allow the engine to
cool at least 15 minutes or until the coolant
ll cap is cool to the touch before removing
the coolant ll cap.