Toro TX525 - Narrow Track Installation

DRIVE SYSTEM
7-73TX525 Service Manual Rev. 000
6. Push the tension wheel toward the rear of the unit to
move the tension arm against the frame (Fig. 1535).
(If it does not touch the frame, continue turning the
tensioning screw until it does.)
Fig 1535 PICT-5342
7. Begin removing the track at the top of the tension
wheel, prying it off of the wheel while rotating the
track forwards (Fig. 1536).
Fig 1536 PICT-5344
8. When the track is off of the tension wheel, remove it
from the road wheel and drive sprocket (Fig. 1537).
Fig 1537 PICT-5346
Narrow Track Installation
Important: Before installing the track, use the
Alignment Tool Toro P/N 110-0069 for proper
alignment between the drive sprocket and the
front tension wheel. Refer to “Track Guide
Alignment” on page 7-3.
1. Beginning at the drive sprocket, coil the track around
thesprocket,ensuringthatthelugsonthetrackt
between the spacers on the sprocket (Fig. 1538).
Fig 1538 PICT-5345