Toro TX525 - Tensioner Wheel Bearing Installation - Narrow Track

DRIVE SYSTEM
7-99TX525 Service Manual Rev. 000
Note: The raised inner race of the bearing should
be facing outward on both bearings on the
tensionerwheel(Fig.1628).
Fig 1628 CLR DSC-0810
Tensioner Wheel Bearing Installation -
Narrow Track
1. Presstherstbearinginsotheouterbearingraceis
ushwiththecenterhub.
2. Turn the tensioner wheel over and install the spacer
centered on the inner race (tensioner wheel bolt can
be used to keep the spacer centered to the bearing
inner race) and press the second bearing in until the
spacer is captured between the bearings.
Important: Press on outer bearing race only, other-
wise bearing damage could occur.
Note: Theouterraceofeachbearingisushwith
thecenterhubofthetensionerwheel(Fig.
1629).
Fig 1629 CLR DSC-0811