Toro TX525 - Page 448

DRIVE SYSTEM
7-71TX525 Service Manual Rev. 000
5. Slide the outer tensioner wheel onto the tensioner
wheel shaft with the installed washer side going on
rst(Fig.1527).
Fig 1527 PICT-4499
6. Apply grease to the bearing area on the outside of
the tensioner wheel (Fig. 1528).
Fig 1528 PICT-4500
7. Slide the second washer over the tensioner wheel
shaft and into the wheel over the grease (Fig. 1529).
Fig 1529 PICT-4501
8. Using a 1-1/2” socket, install a nut securing the ten-
sioner wheel. Torque the nut to 300 ft-lbs. (407 Nm)
(Fig. 1530).
Fig 1530 PICT-4502