Toro TX525 - Page 546

HYDRAULIC TESTING
9-13TX525 Service Manual Rev. 000
6. Thread the hydraulic hose (previously removed) onto
the test port tting and tighten using a 15/16” wrench
(Fig. 1866).
Fig 1866 PICT-3411
7. Plug the test gauge into the test port (Fig. 1867).
Fig 1867 PICT-3412
2. Remove the rear access panel.
3. Place absorbent towel(s) below the hydraulic pump.
4. Using a 15/16” wrench, remove the hydraulic hose
from the pump tting (Fig. 1864).
Fig 1864 PICT-3403
5. Thread the test port tting onto the hydraulic pump
and tighten using a 15/16” wrench (Fig. 1865).
Fig 1865 PICT-3410