6-66 Qualitek mR Owner’s Guide
Once the tester has successfully connected to the Windows Server, the tester will
silently attempt to connect each time at power-up.
Now that the parameters are correctly established, be sure to cycle the key to
Run Mode to save the Windows Server settings to memory.
Network Logging Pathname
The network pathname is the directory path under the Windows Server share
name. The simple case is where there is only one Qualitek mR (QMR) tester. An
example pathname is “/qmr”. However, this will not work when more than one
QMR tester is logging. Folders for each tester should be setup in advance. Thus, an
example for this case is “/qmr-001” for the first QMR tester, and “/qmr-002” for
the second. When there are many QMR testers, it might be good to choose a
naming convention whereby the model number of the tester is used. An example
might be: “/qmr/000001-001M” for tester one, “/qmr/000002-001M” for tester
two, and “/qmr/0000010-001M” for tester ten.
To Next Page
Loading...
