9-125
P0564
5. Defective cruise control setting switch.
• Replace the handlebar switch (left).
• Push the ON/start switch.
• Push the “RES+” side and “SET–” side of the cruise control setting switch, and then check the con-
dition of the DTC using the malfunction mode of the YDT.
6. Check the fuse. (main fuse, ignition fuse, cruise control fuse)
Is resistance ?
YES
Go to step 5.
NO
a. Replace the wire harness.
b. Push the ON/start switch.
c. Push and release the “RES+” side of the cruise control setting switch, and then check the condi-
tion of the DTC using the malfunction mode of the YDT.
Is it in the “Recovered” condition?
YES
Go to step 10, and complete the service.
NO
Go to step 5.
Is it in the “Recovered” condition?
YES
Go to step 10, and complete the service.
NO
Go to step 9.
Is check result OK?
YES
Go to step 7.
NO
a. Replace the fuse.
b. Push the ON/start switch.
c. Push and release the “SET–” side of the cruise control setting switch, and then check the condi-
tion of the DTC using the malfunction mode of the YDT.
Is it in the “Recovered” condition?
YES
Go to step 10, and complete the service.
NO
Go to step 7.
To Next Page