8 System Setup
8.23Safety Logic Circuit
8-247
182582-1CD
182582-1CD
MH900, DX200 Controller
3. In the following setting, SFBOUT01 to SFBOUT04 are available in the
safety logic circuit and SFBOUT05 to SFBOUT08 are available on the
functional safety board as the first board. After changing the setting,
the status in the title line becomes “NOT DONE” and “WRITE” menu is
displayed. Update the data.
4. When the data update is completed, the status in the title line becomes
“DONE” and the “WRITE” menu disappears.
5. When either “NOT USED” or “YSF25-E #n” is set, the output signal in
the safety logic circuit is not available.
“NOT DONE”
is displayed.
“WRITE” menu
is displayed.
When using as the
output signal in the
safety logic circuit,
select “YSF21-E” .
To Next Page
Loading...
