YASKAWA DX200 - Page 448

12 Modification of System Configuration
12.3Addition of Base and Station Axes
12-20
182582-1CD
182582-1CD
MH900, DX200 Controller
12.3.1.2 Connection Setting
In the CONNECT window, it is specified that each axis of each control
group is connected to which connector of the SERVO board, which break
of the contactor unit, which converter, and which overrun signal.
1. Confirm the type of each control group in the CONNECT window.
– The connection status of each control group is displayed.
[CONNECT(STO) window]
[CONNECT (CONTACTOR) window]
448 of 552