www.dadehpardazan.ir 88594014-15
2.4 Monitor Displays (Un)
2-9
2.4 Monitor Displays (Un)
The monitor displays can be used for monitoring the reference values, I/O signal status, and SERVOPACK
internal status.
For details, refer to 8.2 Viewing Monitor Displays.
The panel operator displays numbers beginning with Un.
Display Example for Motor Moving Speed
The following table outlines the procedures neces
sary to view the motor moving speed (Un000).
Step
Display after
Operation
Keys Operation
1 Press the MODE/SET Key to select the monitor display.
2
If Un000 is not displayed, press the UP or the DOWN Key
to select
Un000.
3
Press the DATA/SHIFT Key for approximately one second
to display the
data of Un000.
4
Press the DATA/SHIFT Key for approximately one second
to return to the display of monitor number (step 1).
MODE
SET
DATA
To Next Page
Loading...
