YASKAWA V1000 Series Installation & Start-Up Manual

118 YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
4.3 Start-up Flowcharts
4.3 Start-up Flowcharts
The flowcharts in this section summarize basic steps required to start-up the drive.
Use the flowcharts to determine the most appropriate start-up method for a given
application. The charts are intended as a quick reference to help familiarize the user
with start-up procedures. Refer to Basic Parameter Adjustments on page 124 and
perform all checks to ensure a proper drive start-up.
Flowchart Objective Page
A Basic start-up sequence for drive operation. 119
B V/f Motor Control Set-Up 120
C
Operation in Open Loop Vector Control (OLV) (high performance and high precision
operation without an encoder).
121
D
Operate a permanent magnet (PM) motor in OLV Control (compatible with both IPM and
SPM motors).
122
E Set-up of drive using application specific selections. 123

YASKAWA V1000 Series Specifications

General

Model	V1000 Series
Series	V1000
Output Frequency	0.1 to 400 Hz
Overload Capacity	150% for 60 seconds
Type	AC Drive
Control Method	V/f Control
Input Voltage	200-240V, 380-480V
Output Voltage	0 to Input Voltage
Power Range	0.1 to 18.5 kW
Horsepower	0.2 to 25 HP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault
Communication Interfaces	Modbus RTU
Enclosure	IP20
Ambient Temperature	-10 to +50°C
Storage Temperature	-20 to +60°C
Humidity	5 to 95% RH (non-condensing)
Cooling Method	Fan Cooled