YASKAWA V1000 Series Installation & Start-Up Manual

290 YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
7.1 Section Safety
7.1 Section Safety
DANGER
Electrical Shock Hazard
Do not connect or disconnect wiring while the power is on.
Failure to comply will result in death or serious injury.
Disconnect all power to the drive, wait at least five minutes after
all indicators are off, measure the DC bus voltage to confirm safe
level, and check for unsafe voltages before servicing to prevent
electric shock. The internal capacitor remains charged even after
the power supply is turned off. The charge indicator LED will
extinguish when the DC bus voltage is below 50 Vdc.
WARNING
Electrical Shock Hazard
Do not operate equipment with covers removed.
Failure to comply could result in death or serious injury.
The diagrams in this section may show drives without covers or
safety shields to show details. Be sure to reinstall covers or shields
before operating the drives and run the drives according to the
instructions described in this manual.
Do not remove covers or touch circuit boards while the power
is on.
Failure to comply could result in death or serious injury.

YASKAWA V1000 Series Specifications

General

Model	V1000 Series
Series	V1000
Output Frequency	0.1 to 400 Hz
Overload Capacity	150% for 60 seconds
Type	AC Drive
Control Method	V/f Control
Input Voltage	200-240V, 380-480V
Output Voltage	0 to Input Voltage
Power Range	0.1 to 18.5 kW
Horsepower	0.2 to 25 HP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault
Communication Interfaces	Modbus RTU
Enclosure	IP20
Ambient Temperature	-10 to +50°C
Storage Temperature	-20 to +60°C
Humidity	5 to 95% RH (non-condensing)
Cooling Method	Fan Cooled