22 YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
1.1 Section Safety
1.1 Section Safety
CAUTION
Do not carry the drive by the front cover.
Failure to comply may cause the main body of the drive to fall,
resulting in minor or moderate injury.
NOTICE
Observe proper electrostatic discharge procedures (ESD) when
handling the drive and circuit boards.
Failure to comply may result in ESD damage to the drive circuitry.
A motor connected to a PWM drive may operate at a higher
temperature than a utility-fed motor and the operating speed
range may reduce motor cooling capacity.
Ensure that the motor is suitable for inverter duty and/or the motor
service factor is adequate to accommodate the additional heating
with the intended operating conditions.
To Next Page
Loading...
