YASKAWA V1000 Series Installation & Start-Up Manual

D.2 European Standards
442 YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
■ Guarding Against Harmful Materials
When installing IP20/Open-Chassis drives, use an enclosure that prevents foreign
material from entering the drive from above or below.
■ Grounding
The drive is designed to be used in T-N (grounded neutral point) networks. If
installing the drive in other types of grounded systems, contact your dealer or
Yaskawa for instructions.
Wiring Diagram Example
The wiring diagram in Figure D.2 illustrates compliance with the Low Voltage
Directive.
◆ EMC Guidelines Compliance
This drive is tested according to European standards EN61800-3 and it complies
with the EMC guidelines. Refer to EMC Filter Installation on page 302 for details
on EMC filter selection and installation.

YASKAWA V1000 Series Specifications

General

Model	V1000 Series
Series	V1000
Output Frequency	0.1 to 400 Hz
Overload Capacity	150% for 60 seconds
Type	AC Drive
Control Method	V/f Control
Input Voltage	200-240V, 380-480V
Output Voltage	0 to Input Voltage
Power Range	0.1 to 18.5 kW
Horsepower	0.2 to 25 HP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault
Communication Interfaces	Modbus RTU
Enclosure	IP20
Ambient Temperature	-10 to +50°C
Storage Temperature	-20 to +60°C
Humidity	5 to 95% RH (non-condensing)
Cooling Method	Fan Cooled