YASKAWA V1000 Series Installation & Start-Up Manual

4.1 Safety Section
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07) 99
Start-Up Programming & Operation
4
Electrical Shock Hazard
• Do not touch any terminals before the capacitors have fully
discharged.
Failure to comply could result in death or serious injury.
Before wiring terminals, disconnect all power to the equipment.
The internal capacitor remains charged even after the power
supply is turned off. The charge indicator LED will extinguish
when the DC bus voltage is below 50 Vdc. To prevent electric
shock, wait at least five minutes after all indicators are off and
measure the DC bus voltage level to confirm safe level.
• Do not allow unqualified personnel to perform work on the
drive.
Failure to comply could result in death or serious injury.
Installation, maintenance, inspection, and servicing must be
performed only by authorized personnel familiar with installation,
adjustment and maintenance of AC drives.
• Do not perform work on the drive while wearing loose
clothing, jewelry or without eye protection.
Failure to comply could result in death or serious injury.
Remove all metal objects such as watches and rings, secure loose
clothing, and wear eye protection before beginning work on the
drive.
• Do not remove covers or touch circuit boards while the
power is on.
Failure to comply could result in death or serious injury.
WARNING

YASKAWA V1000 Series Specifications

General

Model	V1000 Series
Series	V1000
Output Frequency	0.1 to 400 Hz
Overload Capacity	150% for 60 seconds
Type	AC Drive
Control Method	V/f Control
Input Voltage	200-240V, 380-480V
Output Voltage	0 to Input Voltage
Power Range	0.1 to 18.5 kW
Horsepower	0.2 to 25 HP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault
Communication Interfaces	Modbus RTU
Enclosure	IP20
Ambient Temperature	-10 to +50°C
Storage Temperature	-20 to +60°C
Humidity	5 to 95% RH (non-condensing)
Cooling Method	Fan Cooled