ZyXEL Communications ZyWALL 310 - 31.3.1 SSO Configuration Commands; 31.3.2 SSO Show Commands

Chapter 31 Web Authentication
ZyWALL Series CLI Reference Guide
258
31.3.1 SSO Configuration Commands
Use these commands to configure the Zyxel Device to communicate with SSO.
31.3.2 SSO Show Commands
You don’t need to enter the configuration mode before you can use these commands. Use them to
see SSO configurations done.
Table 132 SSO Commands and Subcommnds
COMMAND DESCRIPTION
sso agent primary
Enters SSO primary agent subcommand mode.
sso agent secondary
Enters secondary agent subcommand mode. A secondary agent is an
optional backup SSO agent.
router(config-sso-
primary)#
router(config-sso-
secondary)#
[no] ip <w.x.y.z>
Sets the primary or secondary SSO agent ipv4 address. Use [no] to disable
the IPv4 address.
Type the IPv4 address of the SSO agent. The Zyxel Device and the SSO agent
must be in the same domain and be able to communicate with each other.
router(config-sso-
primary)#
router(config-sso-
secondary)# [no]
port <1025..65535>
Sets the primary or secondary agent port <1025..65535>. Use [no] to
disable the port. Type the same port number here as in the Agent Listening
Port field on the SSO agent. Type a number ranging from 1025 to 65535.
sso presharekey
<preshared key>
Sets the SSO pre-shared key. Type 8-32 printable ASCII characters or exactly 32
hex characters (0-9; a-f). The Agent PreShareKey is used to encrypt
communications between the Zyxel Device and the SSO agent
sso encrypted-
presharekey <ciphertext>
Sets the SSO encrypted pre-shared key.
sso_port <1025..65535>
Sets the SSO listening port. This port is used to wait for receiving information
from Agent. Type a number ranging from 1025 to 65535.
Table 133 SSO Show Commands
COMMAND DESCRIPTION
show sso agent
Displays primary and secondary agent IP and Port configurations.
show sso agent
primary
Displays primary agent IP and Port configurations.
show sso agent
secondary
Displays secondary agent IP and Port configurations.
show sso agent status
Displays primary and secondary agent status.
show sso port
Displays the ZySSO port configured.
show sso presharekey
Shows the configured ZySSO presharekey.